Skip to content
  • Delivery: Courier €17.99 · free from €199 · collection in Prešov
  • Payment: Cash on delivery, Bank transfer
0911 607 139Mon–Fri 8–17, Sat 8–12
Basket

Advice

How to fit a transition strip

Ways of fitting step by step. Which to choose depends on the surface and on whether the floors are at the same height. Gluing needs no drilling, and with concealed fixing no screws are visible.

MethodForSurfaceLevelling rangeExpansion gap
Gluingself-adhesive profiles, floors of the same heightTo be added by the shopTo be added by the shopTo be added by the shop
Screw into a wall plugdrilled profilesTo be added by the shopTo be added by the shopTo be added by the shop
Concealed WELL fixingconcealed fixing, floors of different heightsTo be added by the shopdepends on the product, see its parametersTo be added by the shop
Concealed PRINZ fixingconcealed fixingTo be added by the shopTo be added by the shopTo be added by the shop
Method 01

Gluing

self-adhesive profiles
  1. Degrease and clean the surface
  2. Peel off the protective paper and place the profile
  3. Press it down gradually along its whole length
A diagram, not a technical drawing. Photos from the manufacturer’s instructions will be added.

Tip from the shop: To be added by the shop

Method 02

Screw into a wall plug

drilled profiles
  1. Mark the hole centres using the profile
  2. Drill holes with a diameter to suit the wall plug
  3. The hole depth is the plug length plus 5 to 10 mm
  4. Insert the wall plugs
  5. Place the profile and drive in the countersunk screws
A diagram, not a technical drawing. Photos from the manufacturer’s instructions will be added.

Tip from the shop: To be added by the shop

Method 03

Concealed WELL fixing

steel anchor
  1. Drill 6 mm holes to a depth of 40 mm
  2. Insert the wall plugs
  3. Slide the steel anchors into the groove of the profile
  4. Place the profile
  5. Tap it home through a wooden block
A diagram, not a technical drawing. Photos from the manufacturer’s instructions will be added.

Tip from the shop: To be added by the shop

Method 04

Concealed PRINZ fixing

plastic anchor
  1. Drill 6 mm holes to a depth of 40 mm
  2. To be added by the shop Further steps from the manufacturer’s instructions
A diagram, not a technical drawing. Photos from the manufacturer’s instructions will be added.

Tip from the shop: To be added by the shop